The car DVR / dash cam recording is intermittent If the camera has not been used for some time and the internal battery is fully discharged, it may take a few minutes before there is sufficient energy from the power adapter to charge the battery and power the dash camera. This can happen if the internal battery is heavily discharged. This may give the impression recording has stopped but it will still be recording in background.Ĭamera does not start recording after ignition switched on This feature will switch off the LCD screen after a selected time in order to reduce distraction at night. Turn off the back light or enable power save function. For larger SD cards this feature is not required.
When movement is detected the camera will start recording again. For smaller SD cards, this feature will stop recording whenever no motion is detected in front of the camera. Products have reverse connection protection.Turn off motion detection feature.When the car is in the state of ignition, the step-down line is always in working state when the car is out of fire, if the battery voltage falls below the set protection voltage, it will automatically turn off after 100 s (+/-10s) to protect the battery.(due to the influence of components, equipment accuracy and wire voltage drop, there may be about 0.2V deviation in 12V gear and 0.4V deviation in 24V gear, but it does not affect the actual use.) Users can adjust the specific protection voltage according to their own power requirements.
Four gears are set for the input 12V/24V. This product realizes the change of the automobile battery protection voltage by adjusting the step-down switch gear.Low voltage protection function will detect when the battery voltage is getting too low and automatically switch off the device to guarantee that the vehicle will start normally.
When connected to the battery it will continually supply power even after the car is turned off.With the dash cam hardwired in, it will be powered on 24/7 so users can monitor car even when the car’s battery is turned off. The myGEKOgear hardwire kit is designed to help users hardwire in their dash cam to the car battery.
0 kommentar(er)
